#Skylight led panel install#

Consult the dealer or an experienced rad ioffV technician for help.Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.Increase the separation between the equipment and the receiver.Reorient or relocate the receiving antenna.The user is encouraged to try to correct the interference by one or more of the following measures: This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause ha rmful interference to radio or television reception, which can be determined by turn ing the equipment off and on. These limits are designed to provide reasonable protection against harmful interference in a residential installation. NOTE: This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to part 15 of the FCC Rules. this device must accept any interference received, including interference that may cause undesired operation.this device may not cause harmful interference and.Operation is subject to the following two conditions: This device complies with Part 15 of the FCC Rules. 3e) and restore electrical power.Ĭhanges or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. 3c) and sliding it to the left to secure it in place using the metal anchors (fig. Push the LED panel toward the ceiling (fig.The metal anchors of the mounting plate should now automatically align with the slots of the LED panel (fig 3b). Lift the LED panel and insert the anchors of the back first inside its slots (fig.

Locate the slots on the LED panel and the metal anchors on the mounting plate.Connect the ground wire (G) from the light fixture to the ground supply wire (G) from the junction box using a wire connector (fig. Connect the black wire (L) from the light fixture to the black supply wi re (L) from the junction box using a wire connector. Connect the white wire (N) from the light fixture to the white supply wire (N) from the junction box using a wire connector.

Suspend the LED panel in the air using the wired hooks by fixing them to the notch of the mounting plate (fig.

Place the LED panel under the mounting plate making sure that the arrow label points to the left as the mounting plate.

Screw the retaining screws into the wall anchors (fig.

#Skylight led panel install#

Install the mounting plate to the junction box using the 2 junction box screws. Place the mounting plate so that the arrow label points to the left.Drill pilot holes in the ceiling with a ¼ in (6.5 mm) drill bit.Unscrew the junction box screws and remove the mounting plate. Place marks on the ceiling where the support screw holes are located (fig.Place the mounting plate so that the arrow label points to the left (fig. Install the mounting plate temporarily on the junction box using the two junction box screws.Ensure the power is off before continuing. Turn off power at the circuit breaker and the light switch.INSTALLATION ON GYPSUM CEILING, SURFACE MOUNTING Switch off the main electrical supply from the fuse box/circuit breaker before installing the unit or doing any maintenance.